Repair costs
Evaporator Fan Replacement: Price Band
The fan behind the freezer wall, what it costs to replace, and what decides the figure.
Viking Repair Service Los Angeleson site 8am to 8pm, every day of the weekcalls picked up 24/7
The figures on this page
Usual range for this repair
$300$610
Agreed with you in exact figures before anything is opened, ordered or fitted.
- Service call
- $89, and it comes off the repair once you approve it
- Refrigeration fan or defrost system
- $300$610
What sits behind each line
- The fan and its motor
- The part itself is the modest half of this job. Most of the band is the work of reaching it and putting the compartment back as it was.
- Getting to it
- The fan sits behind the rear panel of a compartment, so shelving comes out, the contents come out, and whatever has frozen around it is thawed first.
- The ice that came with it
- A fan that has been turning against frost leaves a coil to be cleared first, or the new motor meets the same block.
- The cycle afterwards
- The compartment is brought back down and watched running before the panel goes on, because a fan that spins freely on the bench can still foul once boxed in.
The rail above is the band this repair is quoted from, and the table under it breaks the job into its parts. Row one is the fan itself, which is rarely the expensive half. Viking Repair Service Los Angeles will tell you which end of the band your cabinet sits at, on (213) 799-7879, once the rear panel is off.
What the fan is for, and how it gives up
Row one names a part most owners never see. Cold is made at one coil and then has to be carried to the shelves, and without moving air the coil frosts over while the compartment above it warms. These motors fail slowly: a bearing that grinds, a blade catching ice, a winding that stops answering. The first sign is usually noise, or one compartment losing ground while the other holds.
Why access sets the figure
Rows two to four are the reason this band has room in it. An undercounter cabinet can often be worked on where it stands; a column trimmed into joinery has to be drawn forward first, and a heavy custom door adds care to every movement. None of that is guesswork on the day, because the technician has already seen the opening during the diagnosis, so the figure you are given has the access built into it.
What the figure covers, and what it does not
Inside the figure
- The replacement motor and blade, fitted with the harness properly seated.
- Emptying and thawing whatever has to come out to reach the panel.
- Clearing the frost and debris the failing fan left around the coil.
- A full cooling cycle watched through before the compartment is closed up.
Not inside it
- A defrost heater or control found faulty at the same time, quoted as its own line.
- Shelving, bins or door parts already cracked before the technician arrived.
- The $89 visit that found it, which folds into this figure once you approve the work.
How the quote itself should behave
-
Normal
The fan and defrost band, because reaching either part is the same work.
Not normal
A board-band figure for a part behind the freezer panel.
Time to call
Ask which part is being replaced.
-
Normal
The same band whether it is the fan or the heater behind that panel.
Not normal
Two bands added together for one panel coming off.
Time to call
One panel, one job, one figure.
-
Normal
A return visit to fit a fan motor ordered to your serial number.
Not normal
A charge for that visit that was never mentioned on the first.
Time to call
Ask what the fitting visit comes to.
That is the shape of a fan quote here, from the first phone call through to the finished job. Call Viking Repair Service Los Angeles at (213) 799-7879 and say which panel was taken off to find it.
Asked about this figure
- Why does a small fan motor land in the same band as a defrost repair?
- Because the band is priced by the work rather than by the part. Reaching either one means the same emptying, the same panel off and the same cycle watched afterwards, and on a built-in that is most of the hour. The parts differ in price by a little; the labor around them barely differs at all.