Power, controls and light
Control Panel Blank or Flashing
Dark or flickering panel, and the question is whether the food is still cold.
Viking Repair Service Los Angeleson site 8am to 8pm, every day of the weekcalls picked up 24/7
| What you see | Likely cause | Safe check | When to call |
|---|---|---|---|
| The panel is dark and the cabinet is still cold inside | The display has lost its own supply while the cooling side carries on unaffected | Open the door, confirm it is cold and see whether the lamp comes on | This week, while nothing is at risk |
| Figures flicker, blank out, then come back by themselves | A connection behind the panel making and losing contact as the door is used | Note whether it goes when the door is opened or when the cabinet starts | This week. Bring that note to the call |
| Panel dead and the cabinet is not cooling either | The control that runs both has gone down, or nothing is reaching the cabinet | See whether the kitchen breaker has gone, and set it once if so | Today, and move anything irreplaceable |
| The panel lights up but nothing responds to a press | The touch surface has stopped reading, or the control is no longer acting on it | Press each pad once, then leave the cabinet alone for an hour | This week, saying which pads did anything |
The table above separates a panel fault from a cooling fault, which is the whole question on this page. Row one covers a cabinet still doing its job behind a dead display; rows three and four are where the repair moves inside. Tell Viking Repair Service Los Angeles on (213) 799-7879 whether the food is still cold.
A cold cabinet behind a dead panel
Row one is the better outcome and worth settling first. Lighting, cooling and the display do not hang off one supply, so the readout can go while the cabinet holds its temperature. Nothing about that needs hurrying.
When the panel takes the cooling with it
Rows two, three and four move the job inside. An intermittent readout is usually a connection that makes and breaks rather than a part that has died, which is why your note beats any guess. A panel dark while the cabinet is drifting warm is no longer a display question, and it is quoted from the control band.
Normal, not normal, and the line between them
-
Normal
A display that dims itself once the kitchen has been quiet a while.
Not normal
Nothing showing at any hour, however the doors are used.
Time to call
This week, once you are sure the food is still cold.
-
Normal
A brief blink as the cabinet changes what it is doing.
Not normal
Flickering on and off through the day, or figures that will not settle.
Time to call
This week. Write down what happens each time.
-
Normal
Food at the back of a shelf colder than food in the door.
Not normal
A dead panel and a cabinet that is no longer holding cold.
Time to call
Today. That pairing is a cooling call, not a display one.
A dark panel over a cold cabinet is a different job from a dark panel over a warm one. Call Viking Repair Service Los Angeles at (213) 799-7879 and describe the row you are on — that sentence is worth more than a guess at the part.
Safe checks before the visit
-
Open the door and satisfy yourself the cabinet is still cold. A cold cabinet behind a dead panel is the smaller of the two jobs, and knowing which one you have changes what gets booked.
-
Take the kitchen circuit off at the breaker, leave it a minute, then bring it back. Once only. If the panel is still dark after that, leave the breaker where it is.
-
Keep a note of when the display misbehaves and what the cabinet was doing. Faults that come and go are caught on that note far more often than on the bench.
-
Stop there. Nothing further is an owner job on a built-in: the sealed circuit, the wiring behind the grille and anything that needs a panel off belong to the visit. Call Viking Repair Service Los Angeles at (213) 799-7879 and say which of the checks above changed anything.
Asked about this one
- Does a dead control panel mean a new control board?
- Not on its own. A panel can lose its supply, or a connection behind it can work loose, and both are ruled out before a board is considered. Viking Repair Service Los Angeles looks there first, because a board is the dearest part in this group and the easiest one to fit unnecessarily.
- Written by
- Ambrose Fitzwilliam
- Role
- Service technician — refrigeration and sealed systems
- In the trade
- 25 years in the trade